hydraulic cutting machinehonggang cutting machine
cuttingmachine-hg1
0086 15007574137
Home > Resources > F.A.Q

Resources

F.A.Q
How many multi-layer materials suitable for computer automatic cutting machine cutting? In recent years, the market share of computer-based automatic cutting machines has gradually increased, and m...
How to handle the situation where the press platen can not go up? However, no matter how good the quality of the mechanical products is and how well it is maintained, there will always be some size f...
How to operate the cutting machine safely? 1. Since the cutting machine is placed in a dry and ventilated factory or room, the ground needs to be firm and flat, and the machine table should be in a...
How to judge the quality of hydraulic oil? For the cutting machine products, the rolling oil is the basis of its work. The quality of the rolling oil not only affects the normal working of the hydr...
How to handle the abnormal sound of cutting machine and change the hydraulic oil? What happens if the cutting machine suddenly has abnormal noise? A. Insufficient hydraulic oil in the tank, oil ...
How to judge the quality of the cutting machine? 1. Hydraulic cutting machine is of course the most important is the hydraulic system determines the quality, no matter how good the appearance of th...
How can we safely operate the automatic feed cutting machine? First, note: 1. Four-column cutting machine operators must undergo relevant training, master operating skills, and strictly abide by t...
How to set the rise height of the cutting machine? 1. The value of the ascent height is set to rise with the height of the high die working area as the base point. Even if the ascent height is set ...
How to determine the pressure of the cutting machine? The cutting machine pressure calculation method is: system pressure by cylinder piston area; this formula we will calculate, the key is not...
Noise problem (2016-04-12)
There would be two situations for why the cutting press machines produce high and unusual noise. 1)when first time working. 2) After work long time First time working after setting the cutting d...
 We never know the quality until we use the machine. This is a little sad but it's the truth.However, we should listen to our clients.  As the biggest manufacturer(4 workshops, 100 stuffs...
 Common fault   1. When press the “Up” button,  tank  cannot go up. 1)Relief valve spring is all loose state; sliding main spool relief not flexible or damping clogg...
 We pack embossing machine with steel and wooden case as a pallet.and if you order moulds too, we will pack plates and molds together. ...
 We supply oil with die cutting machine and embossing machine in China. For exporting to other countries, we will clear the oil, because it's not allowing oil with machine to export....
How to buy? (2015-04-10)
 Confirm your order-Make PI-Pay Deposite-Produce-Pay balance-Send Products...
How to pay? (2015-04-10)
 We will offer our bank account on PI, mainly By T/T....
16 Item(s) Page 1 of 1 1