Guangdong Honggang Intelligent Equipment Co., Ltd.   (Focus on Hydraulic Cutting Machine Manufacturing Since 1994)
honggang cutting machine

cuttingmachine-hg1
0086 15918086545
Home > Resources > Articles > Manual Hydraulic Cutting Machine Instructions

Resources

Manual Hydraulic Cutting Machine Instructions

Manual Hydraulic Cutting Machine Instructions


This installations is about the manual hydraulic cutting machine, If you are using the cutting machine for the first time, I recommend you take a look at this article.

1. First, turn the cutting depth controller to zero.
2. Turn on the power switch, press the pump start button, run for two minutes, and observe if the motor rotates clockwise.
3. Stack the pull plate, rubber plate, knife mold in the middle of the work table in order.

4. Die setting:
a. Loosen the knife handle.
b. Set the switch to rotate clockwise and the upper platen automatically descends until it stops.
c. Pull the handle up and down to the lowest position to lock.
d. Turn the setting switch to the left and the upper platen will automatically rise.
e. Press the green work button at the same time with both hands to perform the test. The blanking depth is controlled by fine tuning.

f. Fine-tuning: Turn the spinner button, reduce the left hand side, and deepen the right hand side. (Only fine-tuning is done under the condition of cutting)

g. Rising height adjustment: When rotating the rising height controller, the right-hand rotation stroke increases and the left-hand stroke decreases. In the normal production, the above pressure plate is suitable for the top of the knife mold.

Manual Hydraulic Cutting Machine Instructions

Manual Hydraulic Cutting Machine Instructions
http://www.hgcuttingsystems.com