Hydraulic Clicker Press Operation Instructions
Hydraulic
clicker press control switch work button:
The left and right switches must be pressed at the same time. The upper platen can perform the cutting action. When the upper platen is pressed down, both hands must leave the switch. After the cutting is completed, the upper platen will rise. If the two hands do not leave the two buttons, a continuous cutting action will occur.
The stroke setting handle of the hydraulic clicker press control switch:
Rotate the setting switch to the right. After the upper platen is lowered to the specified position, release the stroke setting handle, push the handle to the bottom, and then double-lock the handle. Then the stroke setting is completed.
Hydraulic clicker press control switch setting switch:
Hydraulic clicker press in the process of processing is first of all need to set the knife mold, first placed on the table die cutter, twist the set switch to the right, the upper platen will begin to decline until the upper platen is still and then the handle is locked, complete The above steps are completed.