How can we safely operate the automatic feed cutting machine?

First, note:
1. Four-column cutting machine operators must undergo relevant training, master operating skills, and strictly abide by the safety operation procedures;
2, must comply with the relevant requirements of general machine safety operating procedures.

Second, work seriously before doing:
1. Wear protective articles as required before work and tie the cuffs. Do not wear scarves or gloves. Female workers should wear their hair in their hats;
2. Check the equipment carefully according to the inspection table and lubricate the corresponding refueling parts. And idle test run for 1-2 minutes.

Third, work seriously:
1. When setting the cutter, be sure to loosen the setting handwheel first, so that the setting rod touches the cutting point control switch; otherwise, the cutter setting switch turns ON,

Fourth, produce the set action:
1. When working, the knife should be placed as far as possible in the center of the upper platen to avoid unilateral wear of the machine and affect its life.
2, replace the new knife, if the height is not the same, it should be reset according to the setting method;
3. When cutting, please leave the knife or the sampan board with both hands. It is forbidden to use the hand to assist the knife mold to cut off, so as to avoid danger;
4. If the operator needs to temporarily leave the post, please be sure to turn off the motor switch to prevent improper operation and damage to the machine and other people;
5, to avoid overloading and damage the machine to reduce its service life;
6. Points for attention when adjusting the cutting points;
7. After the knife mold setting work is completed, put the cut materials on the plastic sheet, then put the knife mold on the material, and then push the feed sheet into the cutting area;
8. Press the cutting switch with both hands at the same time. At this time, the cutting platen will press down on the knife mold, and will automatically lift to the position before the start of the cutting until the knife mold cuts the material;
9, when punching the material, if it is found that the material is not completely cut, adjust the cutting depth controller and rotate the "pressure system" clockwise;
If the die is pressed into the rubber plate too deep, the "pressure system" is just rotated counterclockwise. The longer the adjustment time is, the deeper the cutting depth is, and try to adjust until the die is pressed slightly into the rubber plate.
10. Pull the feed plate out of the cutting area and remove the cut material. This completes a blanking process.

Learn more about automatic feed cutting machine: http://www.hgcuttingsystems.com