Guangdong Honggang Intelligent Equipment Co., Ltd.   (Focus on Hydraulic Cutting Machine Manufacturing Since 1994)
honggang cutting machine

cuttingmachine-hg1
0086 15918086545
Home > Resources > Articles > How To Install And Test The Steel Mould Cutting Die?

Resources

How To Install And Test The Steel Mould Cutting Die?

How to install and test the steel mould cutting die?

Honggang Cutting Machine cutting die installation adjustment:

1) In the oil pump start and stop interface, press the "manual operation" button to enter the manual operation screen.
2) Press the "Activate" button to activate this screen. Otherwise, the function operation buttons in this interface are invalid. (After activating the manual operation interface, the external button of the machine is invalid)
3) Put the die to be installed on the pull plate, press the "pull the plate to move forward" button and send the die into the cutting zone.
4) Adjust the height of the cutting platen by pressing the "Plate Jog up" or "Pressure plate jog down" on the panel.
Pressure plate close to die. Then use a clamp or mounting wire to fix the die on the cutting platen.
5) After the installation is completed, press the "Operation Release" button to release the active state of this screen.
6) Press "Home" to return to the pump start/stop screen.

cutting die

mould cutting die